Riflespeed Gas Tube

Riflespeed Stainless Steel Straight Gas Tube — for AR‑15 & AR‑10

A stainless steel straight gas tube compatible with Riflespeed gas controls for AR‑15 and AR‑10 platforms. Designed to be used with straight‑tube gas control systems and available in common gas system lengths. Ships with roll pin. Made in the USA.

Features

• Straight stainless steel construction for use with adjustable Riflespeed gas controls or equivalent straight gas control systems
• Available lengths: Micro, Pistol, Carbine, Midlength, Intermediate, Rifle (see measurement table below)
• Includes roll pin for installation
• Intended for use with straight gas tube gas blocks and indexed gas controls (verify compatibility before ordering)

Gas system receiver‑to‑gas‑block measurements

(Measure from the face of the upper receiver to the center of the gas‑block journal — not overall tube tip‑to‑tip.)

• Micro: 2.78 in
• Pistol: 4.30 in
• Carbine: 7.30 in
• Midlength: 9.30 in
• Intermediate: 11.18 in
• Rifle: 12.60 in
• Rifle +1: 13.60 in

Important fit notes from Riflespeed

• Some “Intermediate” and “Micro” designations vary by manufacturer. The Riflespeed intermediate option measures 13.65" tip‑to‑tip; Wilson Combat’s reported intermediate is 13.25" tip‑to‑tip. Our Micro length measures 5.240" tip‑to‑tip. These tip‑to‑tip numbers are different from the receiver‑to‑gas‑block measurements listed above. Verify which version your rifle requires before purchasing.
• Intended for straight gas tube systems only. Confirm that your gas block alignment and barrel journal diameter are compatible with a straight tube prior to installation.
• Follow manufacturer torque and installation instructions when fitting gas tubes and gas controls.